Getting start #

Table of Content #

• Getting start
  • Table of Content
  • Folder Structure
  • Introduction to git branches
  • Building and Starting the TSNPerf

Folder Structure #

.
├── docs                     //documents for ZIGGO
├── figs                     //figures for docs
├── hardware                //hareware code, for PL part(pkt_gen, time sync in FPGA)
├── readme.md                  //readme for whole project
├── software                //software code, for ps part(pkt_gen, time sync)
└── testbed-build           //code for building testbed

Introduction to git branches #

The branches of TSNPerf submitted this time can be divided into three categories. But the main branch is inconvenient to use in two ways. In order to solve the above two limitations, we have also submitted two patch branches.

• The main branch contains basic time synchronization and pkt_gen functions, as well as online analysis functions. However, its limitation is that it can only send Ethernet of MTU (1500B) size, and due to the limited performance of the zynq development board, online analysis may cause packet loss.
• packet_resize branch can send Ethernet frames of any size (64B-1500B).
• offline_analyse branch can forward the data packets to the PC for offline analysis to avoid packet loss.

Note1: When switch to ‘packet_resize’ branch, you also need to modify the software/config/flow.json

{
        "job_id": 0, 
        "flow_id": 0,
        "src": 1,
        "dst": 2,
        "period": 2048,
        "MD": 1024,
        "packet_size": 750 // add this attribute 
 },

Note2: When switch to ‘offline_anaylze’ branch, you need to link device to anthor PC (linux) by wire in ETH1.

Building and Starting the TSNPerf #

Set up the FPGA board and initialize PS system

Compile software code, run the time synchronization & pkt _gen_app